Where is the best place to plug in the splitter s cable

The splitter's cables should be plugged into the input port from the source device and the output ports to the devices you want to connect.Ethernet Splitter SetupFor an Ethernet splitter, there are typically two matching adapters: one near the router or switch and one near the destination devices. The input cable from your router or wall port goes into the single input port of the first splitter. Then, a single Ethernet cable runs to the second splitter, which has two output ports for connecting your devices, such as computers or printers. Each device shares the bandwidth of the single cable, and speeds are limited to 100 Mbps per connection if using a standard splitter .Coaxial Cable Splitter SetupFor a coaxial cable splitter (commonly used for TV or internet), the main cable from the service provider should be connected to the input port of the splitter. The output ports are then used to connect to your TVs, modems, or other devices. Make sure the connectors are tightened properly to avoid signal loss .Key TipsLabel ports if possible to avoid confusion between input and output.Use matching splitters for Ethernet setups to ensure proper signal separation.Check for power requirements: passive splitters do not need power, while some active splitters or switches require an external power source.Avoid overloading: splitters divide the signal, so connecting too many devices can reduce performance. By following these guidelines, you can ensure that your splitter distributes the signal correctly and maintains stable connections for all connected devices.