How to use a fiber optic patch cord stripper

A fiber optic thermal stripper safely removes the protective coating from optical fibers using controlled heat, reducing the risk of fiber breakage.PreparationCharge the device: Ensure the thermal stripper's lithium-ion battery is fully charged before use ( ).Select the fiber holder: Choose the appropriate fiber holder for your patch cord type (single-mode, multi-mode, or ribbon) ( ).Set the temperature: Start with a moderate temperature (e.g., 90°C–100°C for single-mode fibers). Adjust higher if the coating does not strip easily ( ).Stripping ProcedureInsert the fiber: Place the fiber into the fiber holder, exposing the length of fiber to be stripped ( ).Close the covers: Secure both covers of the thermal stripper to ensure even heating ( ).Activate the heater: Turn on the device and wait for the indicator light to show the desired temperature is reached. A solid green light and a beep usually indicate readiness ( ).Strip the fiber: Press and hold the moveable fixture down and slowly pull the fiber from the main body. The coating will be removed without damaging the glass core ( ).Clean the fiber: Use a lint-free wipe with alcohol to remove any residue from the stripped fiber ( ).Tips and PrecautionsTake small sections at a time: Strip in increments (e.g., 6–8mm) to avoid stressing the fiber ( ).Angle the stripper correctly: Hold the fiber at a slight angle (around 45°) to reduce stress and prevent breakage ( ).Avoid overheating: Excessive heat can damage the fiber; start low and increase gradually if needed ( ).Clean the device: Remove debris from the fiber holder and heating area after each use ( ).Safety: The thermal stripper gets hot; handle with care to avoid burns ( ). By following these steps, you can efficiently strip fiber optic patch cords with minimal risk of breakage, preparing them for splicing or connectorization.